The continuous advancement of technology means that the lamps on the market today are becoming more and more intelligent, especially LED lamps, including RGB floodlights, many of which are equipped with remote controls. This remote control allows users to remotely control the turning on and off of the lamps, providing great convenience. However, after purchasing the RGB floodlight, users need to go through a pairing process to connect the remote control to the lamp. So, how to pair the remote control with the Aglare RGB floodlight?
Before starting the pairing, it is crucial to confirm the model of the remote control, because there are different types of remote controls such as crystal frequency and chips on the market.
Once the model is determined, you can follow the steps below to pair:
1. First connect the RGB floodlight to the power supply, then find the button on the back of the RGB floodlight and press it for 5 seconds
2. Enter the pairing mode and the red light will light up
3. Press the button on the remote control and the light will flash once, indicating that the pairing is successful.
4. Press and hold the button again for 5 seconds to exit the code matching mode
5. Then you can use the controller to control the light
Here is the Aglare RGB floodlight with remote control procedure SE2 pairing video
Common problems and solutions for pairing the remote control with the RGB floodlight
1. The light does not flash or respond
• Check the power supply: Make sure the light is properly connected to the power supply and turned on.
• Check the remote control: Make sure the remote control has sufficient power and is not damaged.
• Retry pairing: Try to enter pairing mode again.
2. The remote control cannot control the light
• Check the frequency: Make sure the remote control and the light are using the same frequency.
• Clear interference: Make sure no other electronic devices are interfering with the signal.
• Reset the light: Reset the light according to the instructions in the user manual and then re-pair.
3. The light keeps flashing
• Check the pairing status: Make sure the light has been successfully paired and stopped flashing.
• Re-pair: If the light keeps flashing, try re-pairing.
Aglare RGB floodlight is very suitable for amusement parks, stages, parties, billboards, playgrounds, and landscapes due to its rich color changes and flexible control features.
Summary
Through the above steps, you can easily pair the remote control with the Aglare RGB floodlight. If you encounter any problems during the pairing process, it is recommended to contact Aglare Lighting's customer support. I hope this information can help you successfully complete the pairing and use your Aglare RGB floodlight.